Well yellow it is...

[Niz55]

For some reason I can get the roll cage in. I am going from the driver side but it won't go into place. The passenger side fits but the driver side doesn't.

Sponsored

 

[FP350S]

Looking forward to completion pics!

 

[Tomster]

For some reason I can get the roll cage in. I am going from the driver side but it won't go into place. The passenger side fits but the driver side doesn't.

Have a look at my install thread. It's tight but will fit

 

[Niz55]

I got in after destroying the paint. This is was really hard task to do it by myself with no help.

 

[Tomster]

I got in after destroying the paint. This is was really hard task to do it by myself with no help.

I hear ya man. I did mine myself as well. I wrapped mine in towels.

 

[Niz55]

Yeah it happens. I should of got it poweder coated but is ok. I will touch it up and wet sand it smooth.

 

[Tomster]

Yeah it happens. I should of got it poweder coated but is ok. I will touch it up and wet sand it smooth.

You'll be fine, do an air brush touch up or go to your automotive paint supply and have it put in paint cans and use a shop vac to take up the overspray.

 

[Niz55]

Damn Ryobi bits keep braking on me. Going to home Depot .

 

[Tomster]

Damn Ryobi bits keep braking on me. Going to home Depot .

You have to use the cobalt drill bits. Use a center punch to ensure your hole is on center as measured.

 

[Niz55]

Watson racing instructions on cutting the frpp rear seat delete side corners is completely bs.

 

[Tomster]

Watson racing instructions on cutting the frpp rear seat delete side corners is completely bs.

Yes, look at my thread. Lots of great alternatives

 

[Niz55]

Way too much cutting. I could of just trimmed the sides about 2 inches and be done with it. Now the damn thing looks ugly.

I will find it way to cover the corner and make it look good.

 

[Niz55]

Same goes to the trim panels. No need to cut it so far off.

 

[Niz55]

I am in process of bolting everything in and for the love of God I cant get the driver side leg into the cage. What am I doing wrong?

 

[Niz55]

Ok I got it in. Finishing up tomorrow.

Sponsored