Underside of front spoiler

[Rimox51]

Can anyone post a photo of the underside of the front spoiler.
I'm looking into an alternate way to mount the front plate.

Thanks

Sponsored

 

[HizliBullet]

Can anyone post a photo of the underside of the front spoiler.
I'm looking into an alternate way to mount the front plate.

Thanks

best way is to watch this, its how to install it but shows the under in different angles

http://www.fordservicecontent.com/Ford_Content/videos/GT350Splitter_3PieceFINAL.mp4

 

[Rimox51]

perfect. Thanks

 

[Hughespj47]

This shows an R, is it the same procedure for the non-R?

 

[mmm635]

This shows an R, is it the same procedure for the non-R?

Don't think so. The R is one piece and the track pack is 3 piece. Watch the video one more time...it is for the standard GT350 and can verify this because I installed the splitter on my car personally.

 

[HizliBullet]

Don't think so. The R is one piece and the track pack is 3 piece. Watch the video one more time...it is for the standard GT350 and can verify this because I installed the splitter on my car personally.

I thought track splitter is still same one piece unit arent they all the same part no?

 

[xt6wagon]

I thought track splitter is still same one piece unit arent they all the same part no?

base, tech, track use the smaller 3 piece splitter. The Shelby lettering has very little space above and below the letters.

The R has a larger one piece splitter. There is a noticeable border of plastic above and below the letters.

 

[shelbyman]

I thought track splitter is still same one piece unit arent they all the same part no?

The R Model splitter is different than the Tech and Track Pkg splitter.

 

[shelbyman]

Installation

Don't think so. The R is one piece and the track pack is 3 piece. Watch the video one more time...it is for the standard GT350 and can verify this because I installed the splitter on my car personally.

I have to install mine as well. Did you encounter any issues? Any advice you can offer. Ohhhh by the way on one of the fastener packet it shows 10 in the parts list but only 8 came in the packet. Are the other 2 removed and reused from the car?:shrug:
Thanks.

 

[mmm635]

I have to install mine as well. Did you encounter any issues? Any advice you can offer. Ohhhh by the way on one of the fastener packet it shows 10 in the parts list but only 8 came in the packet. Are the other 2 removed and reused from the car?:shrug:
Thanks.

You use 8 supplied J-clips. Two are removed from the car and replaced on the outboard splitters, two are added to the outboard splitters, 4 added to the center undertray.

 

[ThreeFiveO]

I installed mine. The four white push pins that are slightly clipped are tough to reach due to the oil and trans coolers on a track pack. I was only able to get my car about a foot off the floor so the four screws that are installed on a 45 degree angle were tough too.

 

[B17drvr]

http://ccmustangbrackets.com/product/2015-mustang-bracket/
Best bracket out there.

Sponsored