**Steeda Can Crusher Install**

[Project Whitemare]

STEEDA ULTRA LITE CHASSIS JACKING RAILS

Tools Needed:
15mm Socket
3/8" Drive Ratchet

Difficulty Level:
1 out of 12 Beers

Parts List:
(1) Driver's Side Rail
(1) Passenger Side Rail
(8) 15mm Bolts

Preparation:
Installation can be performed while vehicle is on the ground.

Video:


Installation:

Remove and Discard the (2) 15mm bolts that lay just inbound of the factory pinch weld towards the front of the vehicle

Remove and Discard the (2) 15mm bolts that are toward the rear

Remove the Bubble Wrap and Plastic Wrap from the Rails

Note: Jacking Rails will only fit one-way. Orient them so that the wedge is towards the center of the vehicle.

Lift the Jacking Rails into place and using the supplied 15mm bolts, torque them down with firm pressure

Repeat the process for the other side

Installation Complete!
​

Sponsored

 

[Chameleon]

Nice write up.

 

[M3Convert]

Very timely! Thanks. Mine arrived last week and going on this weekend. The look like they'll be more like skid plates for your drop!

 

[Ron@cp-e]

love the build man
awesome work!

 

[ronv95]

About to order them, appreciate the write up!

 

[Cascadia_302]

​

Good write-up!

So I've seen the factory bolts with evidence of blue loctite did you see this on your install?

 

[ronv95]

I didn't notice any blue Loctite on the factory bolts...I did use it though when I installed the rails.

 

[M3Convert]

I didn't notice any blue Loctite on the factory bolts...I did use it though when I installed the rails.

Me too.

 

[ilkhan]

My rails are arriving today and getting installed tomorrow along with some other goodies.

Good write up. Thanks.

 

[ilkhan]

Install done.
Are they supposed to sit flat? Seemed like they weren't quite sitting flush.

Sponsored