Questions

[smann]

So i took off my engine cover today because it made my engine look like it was crooked. It was not sitting properly because of my paxton install (note i didn't install it myself)

So i took it off.. And my bay looks like a cluster f****
is there any way i can clean this up??

I also notice my pulley was rubbing into something.. I pushed it back with my hand but I don't want to break it. Look at pics. Any way I can adjust this?

Lastly, I was doing a pull.. 1st, 2nd, 3rd.. Goes into third but my car starts limping. Took it out of 3rd put it back in, everythings good??

Running stock clutch.
https://imgur.com/a/mFXob

Pulling off my engine cover stripped some of the protection for the pipes (you can see in pics).
Couldn't get my strut tower off because I dont have a deep socket.

Sponsored

 

[MyLilPony]

You can clean it up with some hose relocation but for the most part it is what it is. If you don’t like it trim the cover where it is touching something to move it back to straight.

In the pic you need to pull that back...you can prob just use a zip tie..

Last issue you should pull a log and see what’s up.

 

[smann]

Can anyone tell me what I can pull that back and what I should zip tie it to?

Sponsored