ZPD
Well-Known Member
- Thread starter
- #1
Does anyone keep getting a P2111 error code? (Throttle actuator "A" Control System- stuck open)
If I am driving in stop and go traffic and take off in 1st and then take quickly take my foot off of the gas (imagine the car in front of you takes off and then stops again quickly) and then push the clutch in my car will go into limp mode, idle erratically around 900 rpm, and throttle is totally unresponsive. Red wrench light comes on. I have to pull over to the side of the road, turn off the engine, wait a minute or two and then start it up again. It will crank for about 10 seconds before it actually starts.
I have read the codes with my scanner and get the P2111 code. I took into the dealer and they verified the code and installed a new throttle body but it keeps happening. I will take it to the dealer again but was wondering if anyone experienced the same thing?
2017 GT Premium PP
If I am driving in stop and go traffic and take off in 1st and then take quickly take my foot off of the gas (imagine the car in front of you takes off and then stops again quickly) and then push the clutch in my car will go into limp mode, idle erratically around 900 rpm, and throttle is totally unresponsive. Red wrench light comes on. I have to pull over to the side of the road, turn off the engine, wait a minute or two and then start it up again. It will crank for about 10 seconds before it actually starts.
I have read the codes with my scanner and get the P2111 code. I took into the dealer and they verified the code and installed a new throttle body but it keeps happening. I will take it to the dealer again but was wondering if anyone experienced the same thing?
2017 GT Premium PP
Sponsored