Sponsored

Need Help with HP Spoiler install issue

KipBanger

Member
Joined
Jan 19, 2022
Threads
1
Messages
17
Reaction score
112
Location
Colorado
First Name
Mike
Vehicle(s)
2021 Mustang Mach 1
So I recently installed the HP Spoiler on my Base Mach 1. Seemed like everything was flush, but I noticed I have some small separation on the inside edge of the end sections. All other sides are flush, including the center section. I have tightened the end nuts for the bolts as tight as they will go, and have also tried re-applying pressure at those points. Any suggestions to fix it, or fill the small gap so it is not noticeable without having to remove and reinstall? It is driving me nuts at this point. Any suggestions would be welcome.
image_50384129.JPG
image_50387457.JPG
Sponsored

 

Atlas1

Well-Known Member
Joined
Aug 11, 2018
Threads
20
Messages
2,892
Reaction score
4,847
Location
Everett, WA
Vehicle(s)
2017 Audi S6, 2021 Mach 1 'M1985'
Looks pretty normal from the pics. I’m sure it varies car to car with some being better than others but every Mach I’ve seen up close had the same issue to some degree. On my car it lifts very slightly on the outer edges.
 
OP
OP
KipBanger

KipBanger

Member
Joined
Jan 19, 2022
Threads
1
Messages
17
Reaction score
112
Location
Colorado
First Name
Mike
Vehicle(s)
2021 Mustang Mach 1
Thanks Ctodd1.
Looks pretty normal from the pics. I’m sure it varies car to car with some being better than others but every Mach I’ve seen up close had the same issue to some degree. On my car it lifts very slightly on the outer edges.
Thanks Atlas 1. I appreciate the feedback.
Sponsored

 
 




Top