Kentucky Manley I Beam Rods

[Nctong01]

These are the heavier version of Manley’s I-beam, one step down from the 300m.

Decided to step the goal up so had to go with a bit beefier rod. Waited 2 months for these…lowest you will find these is $1500 shipped after all’s said and done, alongside a substantial wait time (summit says 5/6/2022).

$1400 shipped.

Sponsored

 

[myfast70]

What kind of power are you looking to make and what is the limit on these?

 

[Nctong01]

What kind of power are you looking to make and what is the limit on these?

These are generally said to be good to 1500. I'm going for 1700 initially.

 

[myfast70]

Ok, bummer. Too low for me too, shoot for 2000+ fingers crossed

 

[olaosunt]

Ok, bummer. Too low for me too, shoot for 2000+ fingers crossed

only 2000?
Me , 4000 !
J/K but following in case i can come up with cash .
Not a bd deal considering no wait but not in a hurry either .

 

[myfast70]

only 2000?
Me , 4000 !
J/K but following in case i can come up with cash .
Not a bd deal considering no wait but not in a hurry either .

If 4000 was as streetable and the same expense as 2000 then I'd be shoot for that but that is beyond my income bracket at this point, maybe in a couple more years...

And like I said, if all goes according to my plans & goals I should be at or above the 2000hp mark. I can tell you one thing for sure it is/ will be different thank anything you've seen before ;)

Definitely a deal considering you don't have to wait for some long timeline that will likely be longer than quoted.

 

[Nctong01]

If 4000 was as streetable and the same expense as 2000 then I'd be shoot for that but that is beyond my income bracket at this point, maybe in a couple more years...

And like I said, if all goes according to my plans & goals I should be at or above the 2000hp mark. I can tell you one thing for sure it is/ will be different thank anything you've seen before ;)

Definitely a deal considering you don't have to wait for some long timeline that will likely be longer than quoted.

Nutty man. I would probably look at the 300M rods or even an aluminum rod with the power you're going for. I went to boostlines which at "rated" to 2000, but I'm always of the camp to not run things on the limit.

And ya, I figured if someones looking for this level of rod, no wait and a bit of a discount for a new product would be better than the former.

Sponsored