M1HP Parts # conformation

[Tomster]

If you have the adjustable camber plates from Ford, they are pinned into place for the sake of manufacturing consistency. I don't know if the person here has adjustable plates, but if so, to release them is a seperate procedure covered by another thread.

I didn't read the whole thread, so if I'm off, please forgive.

Sponsored

 

[Tomster]

Alright, I read a bit. I would not opt for the Ford camber plates. If it was me, I'd do vorshlag. Much better quality.

 

[WD Pro]

Shame. Shame. Lol

If I steal photos from another thread, I always try to tag the owner so it’s clear they are not my own.

It stems from an experience I had years ago where some work I had done, crossed the pond, appeared on another forum, with the poster claiming the work was his own (until a neighbour spotted it and informed me !)

WD

 

[Dan2023]

Will do!

I am pretty sure mine are adjustable - the shop that fitted them would have known for sure and would have told me if they weren’t.

Looking at the other thread I just couldn’t see the pin lthat @WD Pro helpfully highlighted in his photo, and the design of the M-18183-MDH plate looks a lot different to the ones I have, or at least what I remember…
Probably worrying about nothing but want to make sure I do it right and have the exact parts a proper HP car would have…
Worst case I’ll just buy some new ones and get them on the car

-0.

I spoke with Mike at Leviton parts, and the M-18183-MDH are indeed a direct fitment for a 21 to 23 Mach 1,
The KR3Z-3D008-A are also a proper fitment,
The difference being the first part number mentioned above are Ford performance parts, where as the part number listed just below are original Ford accessorie,
Hope that helps,

 

[0wen]

I spoke with Mike at Leviton parts, and the M-18183-MDH are indeed a direct fitment for a 21 to 23 Mach 1,
The KR3Z-3D008-A are also a proper fitment,
The difference being the first part number mentioned above are Ford performance parts, where as the part number listed just below are original Ford accessorie,
Hope that helps,

Dave at Levittown confirmed today that they the same as well, which is good news for me!
I'm guessing mine don't have the pin in the photos as that seems to be used by the factory for assembly but that might not be needed when retrofitting.
I'd get the -MDH kit if doing it again, think the pricing with all the hardware etc might be better.

Great service from @LevittownFordParts as usual!

-0.

 

[Dan2023]

Dave at Levittown confirmed today that they the same as well, which is good news for me!
I'm guessing mine don't have the pin in the photos as that seems to be used by the factory for assembly but that might not be needed when retrofitting.
I'd get the -MDH kit if doing it again, think the pricing with all the hardware etc might be better.

Great service from @LevittownFordParts as usual!

-0.

Yes great service at Levittown Ford,
River city Ford, based in Winnipeg Manitoba are also excellent, they have or could locate any part needed

Sponsored