Lund Racing N Gauge

[LethalPerformance]

So I have my nGauge installed in my ac vent and I'm plugging it up to my laptop and it's not finding it. I've done this before with no issues. Can anyone help me out here?

To mount SD, go to Diagnostics---> USB SD.

Hope that helps.

Jared

Sponsored

 

[RockStang]

So I got my nGauge and Lund tune in now. I wasn't given specific instructions to do so but should I be data logging and sending it back to make sure the tune is working well with my car? Of course it "feels" stronger and "feels" likes it's running good but that doesn't mean that it is optimized. Do most folks just install a tune and leave it?

Joe

 

[V8Venom]

How do you remove the air vents so I can place the ngauge on the middle

Remove the faux bezel and then pop out the AC vent. The nGauge pops right in with some electrical tape around the back to help it fit snug.

 

[Schu]

So I got my nGauge and Lund tune in now. I wasn't given specific instructions to do so but should I be data logging and sending it back to make sure the tune is working well with my car? Of course it "feels" stronger and "feels" likes it's running good but that doesn't mean that it is optimized. Do most folks just install a tune and leave it?

Joe

feel free to datalog and send it back to ken and the group and they will have a look. more than likely, unless you have changed a major component, the tune is correct.

 

[rozay]

Remove the faux bezel and then pop out the AC vent. The nGauge pops right in with some electrical tape around the back to help it fit snug.

What about the wire? How do I pop the stuff around ? Is there any screws securing anything

 

[rozay]

question how come when i shut off my car get out and lock it i wait the 5 sec that i programed to shut the ngauge off but does not shut off. Shuts off after a couple min.

 

[rozay]

Installed ngauge to a/c vent . Really easy the way I did it I didn't need to remove any screws just pop out the panels. Took me 30min.

 

[V8Venom]

Installed ngauge to a/c vent . Really easy the way I did it I didn't need to remove any screws just pop out the panels. Took me 30min.

You didn't remove the screws on the driver's side bezel where the trunk release is? I removed those to get that panel off and ran the wire right over the steering wheel. Sorry I didn't get back to you sooner, I am working.

 

[rozay]

no. i will make a video explaining what i did if anyone wants to know

 

[5starr0]

Where do people with premium models with Guages already in the center bezel

 

[argile2000]

no. i will make a video explaining what i did if anyone wants to know

Would like that!

 

[Schu]

I have a non-premium with console mounted gauges...

 

[Process]

Since the 2015 mustang PCM doesn't monitor boost or fuel pressure the gauge doesn't have the ability to read or display those parameters off of the PCM.

However the nGauge is capable of accepting additional aux inputs. So in the near future we will be offering sensor kits for both fuel/oil pressure and boost that will allow you to monitor those things.

Hope that helps.

Jared

It actually kind of does, well it does it through inferred load. I do not think the ngauge can monitor it this way though from the canbus.

This is how the performance pack gauges work.

 

[rozay]

ill post a quick video explaining what i did. sorry if the clip is ass. Im not good with recordings

 

[rozay]

[ame="[MEDIA=youtube]pfz64_jK960[/MEDIA]"]

Sponsored