Lund Racing N Gauge

[DarkSubRosa]

If my ngauge hasn't shipped yet will it come with the updated firmware?

Sponsored

 

[LethalPerformance]

Can it display fuel pressure? Can boost for procharger be displayed somehow on the ngauge

Since the 2015 mustang PCM doesn't monitor boost or fuel pressure the gauge doesn't have the ability to read or display those parameters off of the PCM.

However the nGauge is capable of accepting additional aux inputs. So in the near future we will be offering sensor kits for both fuel/oil pressure and boost that will allow you to monitor those things.

Hope that helps.

Jared

 

[LethalPerformance]

If my ngauge hasn't shipped yet will it come with the updated firmware?

If your gauge hasn't shipped then it would have the newest firmware installed on it.

If you PM me your order number I can verify for you.

Thanks, Jared

 

[rozay]

On my way to pick up my ngauge from power by the hour

 

[rozay]

i was very low on fuel and only use 93. my tune is 93oct. weird thing is i displayed one of the gauges on the ngauge for fuel and it was showing 91 oct. i double check to see if i do have the 93 oct tune and i do have it installed.

 

[DarkSubRosa]

If your gauge hasn't shipped then it would have the newest firmware installed on it.

If you PM me your order number I can verify for you.

Thanks, Jared

It actually just showed up today Jared so I'll double check before I push the tune. I'm waiting on the steeda intake to show up anyway and in the middle of a move so it might be a week or two before I can get to it. Thanks!!!

 

[gundam83]

New Fast Gauges Update is here!!

How did you get it to work? I followed the instructions on lunds site and my needles don't move at all

 

[rio16]

How did you get it to work? I followed the instructions on lunds site and my needles don't move at all

the same here.. mine wasn't moving :gossip:

 

[Schu]

+3 for no gauge/needle movement. Update went perfectly otherwise.

I suspect this had to do with not being asked to "forget model" when I went thru the last portion of the update.

 

[V8Venom]

So I have my nGauge installed in my ac vent and I'm plugging it up to my laptop and it's not finding it. I've done this before with no issues. Can anyone help me out here?

 

[rozay]

Go to settings and look for usb sd

 

[LethalPerformance]

the same here.. mine wasn't moving :gossip:

+3 for no gauge/needle movement. Update went perfectly otherwise.

I suspect this had to do with not being asked to "forget model" when I went thru the last portion of the update.

How did you get it to work? I followed the instructions on lunds site and my needles don't move at all

I'll have a video for you guys in just a few minutes showing how to properly set that up. [emoji106]

 

[V8Venom]

Ok so my computer was having an issue but I put the firmware and new PID on and forgot model, scanned all. So where am I supposed to see the new gauges?? I'm a little confused, obviously. Thanks.

 

[rozay]

How do you remove the air vents so I can place the ngauge on the middle

 

[LethalPerformance]

[ame]

Sponsored