Lid for Ford Performance CAI ?

[mavisky]

Hey Mav-

Would you be interested in fabbing me one up? I will pay you. Please let me know.
Thanks Antony

Perhaps if you were local. There's just w lot more to making this last than it seems as you have trace the template onto the plexiglass, then trim the dealing rubber so it's all level. Drill holes to attch it. Find the right screw and bolts , and then I use 3dnprinted spacers to get the standoff correct on it.

It's not too bad in person, but trying to coach someone through the process remotely severely complicates things.

Sponsored

 

[monte87]

Perhaps if you were local. There's just w lot more to making this last than it seems as you have trace the template onto the plexiglass, then trim the dealing rubber so it's all level. Drill holes to attch it. Find the right screw and bolts , and then I use 3dnprinted spacers to get the standoff correct on it.

It's not too bad in person, but trying to coach someone through the process remotely severely complicates things.

I could do everything else, drill holes dremel sand edges, cut rubber, etc. I just need the plexi cut close to our box and i can make it fit I dont have a jigsaw, sadly..Let me know.

Thanks Anthony

 

[Nightmonkey]

Get e cutter for your Dremel, should do the job.
e.g. https://www.dremel.com/us/en/p/b814-01-2615b814aa

 

[mavisky]

Get e cutter for your Dremel, should do the job.
e.g. https://www.dremel.com/us/en/p/b814-01-2615b814aa

I actually cut mine out with a router attachment for my dremel. Much cleaner for cutting plexi.

Sponsored