Atlas1
Well-Known Member
- Joined
- Aug 11, 2018
- Threads
- 20
- Messages
- 2,892
- Reaction score
- 4,848
- Location
- Everett, WA
- Vehicle(s)
- 2017 Audi S6, 2021 Mach 1 'M1985'
- Thread starter
- #1
*UPDATE on page 5*
Installed the Ford oil-air separator this evening. Everything went well until I finished up and realized that when I unplugged a wiring harness for the install, something must have happened because upon plugging it back in it does not secure with a click. It appears like there’s a small plastic tab that it slides over to secure it and I think it must have broken off. It was tiny to begin with so I think that’s why I didn’t notice anything when it snapped off. Anyone have an idea of what I can do? I want to make sure the harness stays secured while driving! I should have known……… the install went too smooth for something stupid to not pop up at the end
(it’s the harness with the red push clip)
Installed the Ford oil-air separator this evening. Everything went well until I finished up and realized that when I unplugged a wiring harness for the install, something must have happened because upon plugging it back in it does not secure with a click. It appears like there’s a small plastic tab that it slides over to secure it and I think it must have broken off. It was tiny to begin with so I think that’s why I didn’t notice anything when it snapped off. Anyone have an idea of what I can do? I want to make sure the harness stays secured while driving! I should have known……… the install went too smooth for something stupid to not pop up at the end
(it’s the harness with the red push clip)
Sponsored
Last edited: