friedmud
Well-Known Member
Well - I wasn’t sure if I wanted to tell the whole story: but since you asked…How was the install on your RockBlockz? Mine just got here today and I'm going to install them tomorrow. Any tips or tough spots?
Overall, install was “fine”.
The front go on pretty easily (just turn your wheels to get access) - just pay attention to the plastic push pins you are taking out: they have a little slit on one side for you to stick a screwdriver in to pop the inner part out and then you can pull them out (fought with the first one until I noticed). Other than that: follow the pictures they sent. Oh: also think about the shiny metal washers and hoe to use them… they are not mentioned in the instructions but I just put them on under the vanity washers.
The back is a little more tough - definitely need to take the wheels off. You will also need a drill with a 5/16 drill bit to enlarge one of the mounting holes.
All was going well until I went to push in the final plastic mounting pin on the rear tire well… and it snapped (prongs broke off). Grrr. I ended up reusing one of the plastic push pins I had taken out of the front tire well to pin it down for now (plus it has the screws in the two outer holes). I already contacted RockBlockz about - hopefully they will send me one soon. Just rotten luck!
Let me know if there’s something else you have questions about.
Sponsored