Furious18
Well-Known Member
- Thread starter
- #1
So I installed the edelbrock sc and fore level 1e fuel system and I have a p0340 cam position sensor- A circuit code upon start up. Pbd said to check the harness and make sure it isn’t rubbing or anything.
It’s a 2018 a10 with 8k miles so I assume it’s not a bad sensor or alternator, as it was fine prior to install. Does anyone have any suggestions as to what I should look for or advice?
Thanks in advance!
It’s a 2018 a10 with 8k miles so I assume it’s not a bad sensor or alternator, as it was fine prior to install. Does anyone have any suggestions as to what I should look for or advice?
Thanks in advance!
Sponsored