Shelby Nick
Active Member
- Joined
- Oct 30, 2018
- Threads
- 3
- Messages
- 32
- Reaction score
- 45
- Location
- Orange County, Ca
- First Name
- Nick
- Vehicle(s)
- None
- Thread starter
- #1
I was trying to figure out how I was going to get my track tires in the car without ruining the rear seat delete. So I decided to make my own rear seat delete that would act like a table top and be strong enough to hold the weight of the tires. The factory rear seat delete comes out fairly easy, just three bolts hold on. I cut up a piece of half-inch plywood to the approximate fit and wrapped it in some vinyl. You will need to screw in some blocks under the front edge of the plywood to avoid putting any weight on the thick cable. I did drill a hole in the center and used the same screw to keep it secure. I also made the back part out of thick cardboard, felt and vinyl. I thought I would use the back part to dampen the sound on the track but never did. The exhaust was loud, not overwhelming but awesome sounding. I attached a few pictures. I hope this might be useful to some and has not been posted before.
Sponsored