Sponsored

Hard to shift into 1st gear from stop

OP
OP
G8rbcn

G8rbcn

Well-Known Member
Joined
Jun 25, 2019
Threads
5
Messages
51
Reaction score
74
Location
Marietta Georgia
First Name
Scott
Vehicle(s)
2017 Shelby GT350, BMW X5 and Audi A5 SB
Thanks all. I will talk to George at MGW - he helped me with a few things during the original install. Just wanted to see if it could be a Tremec thing that I should have the (cringe) dealer look at.
Sponsored

 

Ltsrock

Well-Known Member
Joined
Dec 14, 2017
Threads
7
Messages
122
Reaction score
56
Location
Denver
First Name
Keith
Vehicle(s)
2017 GT350r Lightning Blue
Thanks all. I will talk to George at MGW - he helped me with a few things during the original install. Just wanted to see if it could be a Tremec thing that I should have the (cringe) dealer look at.
FYI, it very well could be the transmission is bad. My car is currently at the Ford dealership going through dealership hell. The transmission started grinding going into first gear while rolling, then progressed to being difficult (sometimes) to put into first gear at a stop.

Dealership hell = They couldn't get Ford to approve a new transmission and were forced to repair the original. Well guess what? The repair failed and the transmission now grinds between 2nd & 3rd. Ford has finally agreed to replace the trans. The dealership has had my car going on 4 weeks.

The original diagnosis was that the 1st gear syncro was broken/damaged.
If there is any good news in this, the transmission is covered under the 5/50k drive train warranty.

Moral of the story, yes it's very possible that your transmission is defective. YMMV

Keith
 

SVTinAR

Well-Known Member
Joined
Sep 29, 2017
Threads
17
Messages
473
Reaction score
196
Location
Arkansas
First Name
Dan
Vehicle(s)
2017 Shelby GT350, 2003 Lightning & ERA FE Cobra
When it happens you might try putting it into 2nd and then shifting up to first. Sort of a pain to have to do that though. I would suspect it's a shifter issue rather than in the transmission.
 

Pittpa

Well-Known Member
Joined
Jul 26, 2019
Threads
12
Messages
321
Reaction score
201
Location
Pittsburgh PA 'Burbs
First Name
Dave
Vehicle(s)
2019 GT 6MT
Recently I have had several instances of my car not shifting into first gear from a stop. Some details:

1. Car is a 2017 with 11k miles. Installed a MGW shifter about a year and half ago. Love it!
2. This issue usually happens when the car is warm/hot. Not on cold start.
3. Has happened after shifting out of reverse when manuevering in a parking lot.
4. No other shifter/transmission issues (smooth shifts, no other noises)

Thoughts?
Have you tried turning off the engine when this happened and then see if if will let you engage first gear?
 
OP
OP
G8rbcn

G8rbcn

Well-Known Member
Joined
Jun 25, 2019
Threads
5
Messages
51
Reaction score
74
Location
Marietta Georgia
First Name
Scott
Vehicle(s)
2017 Shelby GT350, BMW X5 and Audi A5 SB
Have you tried turning off the engine when this happened and then see if if will let you engage first gear?
I haven't had to turn it off, I usually cycle through it a few times and/or double clutch and it will go into gear. Just pisses off the people behind me that have to wait...
 

Sponsored

Biggsy

Well-Known Member
Joined
May 3, 2018
Threads
206
Messages
2,635
Reaction score
2,102
Location
MD
First Name
Warren
Vehicle(s)
'17 GT PP, '10 Tundra
Did you ever fix the issue. Experiencing the exact same after a clutch install by the dealer
 

dcalero

Well-Known Member
Joined
Mar 26, 2020
Threads
0
Messages
65
Reaction score
29
Location
Florida
Vehicle(s)
2017 GT350 w/Tech Pack
I had this same issue. The reverse lockout had moved. This would cause first gear to jam and not go in. It eventually got so bad that it would go into reverse. I took the boot off and adjusted the reverse lock out nut. After that problem solved. There is a video about how to adjust.
 

yosv0610

Well-Known Member
Joined
Jun 5, 2020
Threads
10
Messages
266
Reaction score
178
Location
Miami
Website
www.instagram.com
First Name
Yosvaldy
Vehicle(s)
2020 Ford Shelby GT350R, RAM 1500 TRX, Dodge Durango RT TnG
Have you tried turning off the engine when this happened and then see if if will let you engage first gear?
I had similar issue today. I was in a stop light, and when it was green I tried to engage first gear but it only allowed me to move the shifter to the left but not up. I tried few times, I depressed the clutch fully, nothing! Then I turned it off and then on, tried again and nothing. So, I engaged 2nd gear and move the car to a parking lot. I tried once it was stopped and 1st gear worked. I moved the shifter in all gears and it worked fine. I turned it off few times and tried and all was good. I was driving the car for 20 min before it happened. And I always let my car warm up before start driving. It only has 777 miles on it. Any thoughts? I have the original shifter, no aftermarket parts, my car is completely stock.
 

Biggsy

Well-Known Member
Joined
May 3, 2018
Threads
206
Messages
2,635
Reaction score
2,102
Location
MD
First Name
Warren
Vehicle(s)
'17 GT PP, '10 Tundra
I had this same issue. The reverse lockout had moved. This would cause first gear to jam and not go in. It eventually got so bad that it would go into reverse. I took the boot off and adjusted the reverse lock out nut. After that problem solved. There is a video about how to adjust.
this gives me hope. When I first noticed, I did adjust it but maybe the wrong way. I’ll try again today. Thanks
 

Biggsy

Well-Known Member
Joined
May 3, 2018
Threads
206
Messages
2,635
Reaction score
2,102
Location
MD
First Name
Warren
Vehicle(s)
'17 GT PP, '10 Tundra
Just tried adjusting the gates. no luck. Think it’s my transmission
 

Sponsored

Biggsy

Well-Known Member
Joined
May 3, 2018
Threads
206
Messages
2,635
Reaction score
2,102
Location
MD
First Name
Warren
Vehicle(s)
'17 GT PP, '10 Tundra
I had similar issue today. I was in a stop light, and when it was green I tried to engage first gear but it only allowed me to move the shifter to the left but not up. I tried few times, I depressed the clutch fully, nothing! Then I turned it off and then on, tried again and nothing. So, I engaged 2nd gear and move the car to a parking lot. I tried once it was stopped and 1st gear worked. I moved the shifter in all gears and it worked fine. I turned it off few times and tried and all was good. I was driving the car for 20 min before it happened. And I always let my car warm up before start driving. It only has 777 miles on it. Any thoughts? I have the original shifter, no aftermarket parts, my car is completely stock.
Sounds like a transmission issue. Maybe synchros? Not sure
 

Caustic Cobra

Well-Known Member
Joined
Apr 20, 2020
Threads
0
Messages
78
Reaction score
73
Location
Hermosa Beach, California
First Name
Michael
Vehicle(s)
2018 GT350, 1965 Sunbeam Mk-1A, Kirkham 289 FIA
I have a standard transmission and I have this issue from time to time as well. First gear is a little rough to get in. There were instances where I thought the car was in gear, but wasn't - made a cringeworthy khhhh noise.
When I posted that here, I was told by members that I wasn't alone, the transmission needed manhandling sometimes. It's not always, but half of the time, first gear needs some forcing. So, it might not be your short shifter, it might be the good ol Tremec.
As stated earlier, I too am sorry to hijack this thread but I am having the exact same issue with my 2018 as well. It's driving me nuts....
 
 








Top