GT350 Install question.

[Laztug]

Hey fellas, i am reaching out to see if anyone has any experience with this install. Am missing a plug? Does anyone have any idea what went wrong?:shrug:

Sponsored

 

[Lonmon]

I had to plug one outlet of my intake tube that wasn't used by the 350im.

 

[Lonmon]

You can look at my under hood install pic in the 350 thread below if you want to see mine. Looking good so far! You will love the top end! Rev limiter comes too quick, haha. I have mine set to 7900!

 

[Laztug]

I managed to get everything on. I still have no idea if it will run, I do not have a tune for the new setup. Wait time should be about a month.:doh:

350 im / tb pmas cai.
I will need longer hoses to connect to the cai. The smaller one is way too short.

 

[Zodiac]

First to install with PMAS intake I assume? Overall how bad was the removal/install of the IM? I'm doing it next weekend. My ngauge and tune will be here Tuesday. I wouldn't risk starting it without the tune to be honest. Why so long for a tune?!

Also you need to spend the $25 for a set of black GT350 coil covers. Will make the engine bay look that much better.

 

[Laztug]

First to install with PMAS intake I assume? Overall how bad was the removal/install of the IM? I'm doing it next weekend. My ngauge and tune will be here Tuesday. I wouldn't risk starting it without the tune to be honest. Why so long for a tune?!

Also you need to spend the $25 for a set of black GT350 coil covers. Will make the engine bay look that much better.

Install.....was pretty tough tbh. Worst part was removing the pins from the rear of the factory IM.
I used the JDM engineering install guide to help me along the way.
http://www.teamjdm.com/jdm-gt350-x-intake-manifold-installation-kit/

I am tuned by AED, the car ran like an animal with the previous FF/lope tune. I can't wait to see what he does with this new setup. I don't mind waiting, the end result will be worth it.

pmas cai had strange hardware in the kit, so i used my own.

 

[15dib]

Awesome, I should be receiving my intake next Friday. I have the same pmas cai. What extra parts did you need for the install?

 

[15dib]

$80 for that install kit? Ouch that's pretty steep.

 

[RubyRedBoost]

$80 for that install kit? Ouch that's pretty steep.

It takes a lot of headache out of the swap. Step by step instructions with good pics. Was well worth the money to me. The Degas hose they provide is one size too small that was my only complaint.

 

[Laztug]

Awesome, I should be receiving my intake next Friday. I have the same pmas cai. What extra parts did you need for the install?

For the JDM eng kit, I needed to get my own bolt for the passenger side purge valve. As stated before, the degas hose was a size too small.

I replaced the allen wrench bolts that came with the pas kit for a pair of hex bolts.

Sponsored