Robottrainer
Well-Known Member
- Thread starter
- #1
Spent the entire day yesterday and today changing out the lower control arm bushings, toe link bushings and rear axles. The control arms and knuckles were tedious. What took up most of the time was getting clearance between the shocks and the axle boots.
I had to find the lower magnaride shock bolt holes to get an 1/8 of clearance. Went out for a ride. Checked it. It's not rubbing but is very close.
Anyone else see this and what did you do to resolve it.
I had to find the lower magnaride shock bolt holes to get an 1/8 of clearance. Went out for a ride. Checked it. It's not rubbing but is very close.
Anyone else see this and what did you do to resolve it.
Sponsored
