Chef jpd
Well-Known Member
- Joined
- Apr 1, 2016
- Threads
- 63
- Messages
- 2,989
- Reaction score
- 3,121
- Location
- Brooklyn, NY
- First Name
- John
- Vehicle(s)
- 2020 GT PP1 6M, Grab ass lime. Ex: 2016 EB PPP CO
- Vehicle Showcase
- 1
- Thread starter
- #1
This has been discussed on other threads, I figured I'd give it it's own topic.
As many of you know, there is a pony molded into the underside of all of our hoods. Rather than just remove the entire hood insulation, I decided to cut out an oval.
I don't have a before pic, so just look under you hood.
Remove the insulator and on the back there is an exact ridge where you can cut that perfectly frames the logo. Cut with a utility knife and reinstall.
The edges will be rough, so I masked it off and hit it with a shot of undercoating. Would have been easier if I did it while it was off the car........
Masked and sprayed
Finished product
Ill do some sort of trim to clean the edges.
Notice the holes on the upper part of the oval, as if it was meant for something......
Also, the spacing of the attaching clips would indicate it was made for this mod.
As many of you know, there is a pony molded into the underside of all of our hoods. Rather than just remove the entire hood insulation, I decided to cut out an oval.
I don't have a before pic, so just look under you hood.
Remove the insulator and on the back there is an exact ridge where you can cut that perfectly frames the logo. Cut with a utility knife and reinstall.
The edges will be rough, so I masked it off and hit it with a shot of undercoating. Would have been easier if I did it while it was off the car........
Masked and sprayed
Finished product
Ill do some sort of trim to clean the edges.
Notice the holes on the upper part of the oval, as if it was meant for something......
Also, the spacing of the attaching clips would indicate it was made for this mod.
Sponsored
Last edited:


