Cannot train TPS sensors

[zerolash]

Basically, it says the right-side front and rear are 3 psi. I have new tps sensors oem Ford. I have tried FOrscan reset, factory reset brake ignition 3 times brake ignition 3 times. I have drove car and it does not go into a reset. Had at a shop they could not reset either. Any ideas. Running stock tires. 2015 PP1. Just a note probably does not matter but after a tune is when I could not reset.

Sponsored

 

[Howitzer]

Did you get ones that operate at the original frequency? I think that's 315mhz. I have a different set of wheels entirely with tpms and I've never had to reset/relearn for the car to recognize the sensors. It just picks them up.

Other than that, there is a tpms learning tool that can be used if the sensors aren't connecting properly. Have you used one of those when you mentioned doing the factory reset? Link: https://lmr.com/item/TPMS19/Mustang-Tpms-Sensor-Training-Tool

Could also be bad sensors...but have a look here, you may find some additional info: https://www.mustang6g.com/forums/threads/tpms-reset.59067/

 

[Skye]

Can you check your part/model #?

I did some research on this past.

I noticed A and B serve primarily Gen 5 (A) and Gen 6 (B) respectively. 2015, when the S550 came about, was when Ford began producing/supporting the M-1180-B.

You're using M-1180-B, yes?

 

[Skye]

I think that's 315mhz. I

https://performanceparts.ford.com/part/M-1180-B

That's my understanding as well: 315MHz.

 

[zerolash]

Tire Pressure Sensor F2GZ1A189AB TPMS35
This what is in the car currently.
I had the original one in there and could not get them to work. This is the training tool I bought.
Arozk TPMS Reset Tool Sensor Relearn Reset Tool for Ford and Mazda Tire Pressure Monitor System Sensor Programming Training Activation Tool TPMS Trigger Tool Motorcraft TPMS19 Transmitter https://a.co/d/fFM1aMV

 

[zerolash]

So simple solution I have the wrong FN ones Jesus

Sponsored