Bullitt mods

[Elp_jc]

And you forgot a large 'Steeda' logo next to the clutch pedal. Ha ha.

Sponsored

 

[jwt]

Very interesting that even with no spring the clutch pressure is not linear.

Heavy or light to be honest muscle memory will take care of it and after a few days you wont notice one way or another unless you're suffering from rickets or something.

Clutch feel with no spring (versus factory or steeda), for me, yes me, subjective me, was better. your mileage may vary

 

[cactus_kid]

Had the Steeda spring installed yesterday. Major difference in clutch feel. No chatter or lurch. Very smooth take up.

 

[cactus_kid]

Today the Borla "plumbers nightmare" was installed. Perfect. Very quiet in "Q" mode. In sport, there is no rasp on downshift. Just good old rice crispy sound .............

 

[jwt]

Pretty sure you said something interesting there Mike, but my eyes refuse to focus on your words from some reason and keep drifting left

 

[Voo Doo]

I think you’re right JW...it must be cold there!!....and Mikey is maybe a Michele?? lol. Just ribbin ya Mikey!!

 

[cactus_kid]

Pretty sure you said something interesting there Mike, but my eyes refuse to focus on your words from some reason and keep drifting left

Same issue on the big Corvette forum board. I'm surrounded by by deviants I tell ya.

 

[cactus_kid]

A few pictures ............. If you're on dial up, you're screwed ........ ;-)

 

[cactus_kid]

Last picture gives a good view of the ground clearance. So far no issues and I drove through the lots at Home Depot and Lowe's. Both of which are speed bump mine fields.

 

[cactus_kid]

Eibach rear sway and lowering spring. Fronts are too shielded to photograph.

Also a half arsed shot of the factory res before being removed.

 

[cactus_kid]

Street tune from Livernois goes in tomorrow. I ordered the GT350 flat bottom steering wheel and short shifter from Steeda today. Shame on Ford for not giving us one. Hell, even my ST Explorer has one.

 

[cactus_kid]

Lastly, the Diode Dynamics smoked side markers came by post today. They too will be installed tomorrow. Car is getting there piece by piece. Just as 'ol Johnny Cash said.

 

[Elp_jc]

Good to hear about the ground clearance with the bulky Borla contraption... but it DID reduce ground clearance, which I find unacceptable. But glad you're satisfied with it . I'll leave my car alone, with the possible exception of the Steeda lower G-brace, and that's only IF there's absolutely no risk of it hitting anything, meaning above the level of the belly pan and chassis rails. Sitting perpendicular to the direction of travel makes it a lot more dangerous than parallel, like the Borla pipe.

 

[Bulldog9]

I don't plan many mods, just have the car a week. My first Mustang (and Ford) Mostly cosmetic at this point.

Hood supports
Coolant Reservoir Cover
Steeda Clutch spring
Steeda Jack Rails
Sho & Go License Plate bracket
Coco Mat Floor mats
Front window tint

 

[cactus_kid]

More exposure than porn hub .................

Sponsored