AIT2 gauge

[Livnpaintball2]

How can i make a seperate post cooler temp indication? Seperate stand alone gauge not N gauge

Sponsored

 

[908ssp]

I bought a stand alone gauge. My manifold had extra unused tapped holes, put the sender in there and wired it up. I never intended to leave it in long term just wanted a reference I could trust when the stock read outs are either wrong from being taken from the wrong place or because they conversion factor isn't set right. It is hard to see in this photo. The brass sender on the right is the one specified by Lund and reads through the nGauge. The black one is on the left side and is a standalone gauge. You can see they are mounted the same relative place.

 

[Livnpaintball2]

I have the Whipple, not sure if it has an extra bung or not. Will have to look today.

 

[esacteksab]

I have the Whipple, not sure if it has an extra bung or not. Will have to look today.

It does. I used http://www.jegs.com/i/AEM/017/30-2014/11054/-1?parentProductId=1183758 And Zeitronix ZT-2.

The sensor is in the intake, I've been out of town for work so haven't hooked it up yet.

Sponsored