Airflow holes

[5cent]

I was searching the forum and have not seen anything about it. Was wondering if anyone has cut the 2 side sections out of the grill. Maybe open the airflow up a little bit. Anyone have information on this?

Sent from my SAMSUNG-SM-G900A using Tapatalk

Sponsored

 

[Obsol3te]

I was searching the forum and have not seen anything about it. Was wondering if anyone has cut the 2 side sections out of the grill. Maybe open the airflow up a little bit. Anyone have information on this?

I took a sharp razor blade to the inner honey comb parts of the grill where the factory air inlet was for the intake.
Just outline the honeycomb a few times and take a screwdriver and hammer to the center of the blocked honeycomb. They'll pop through.
It looks clean as well.

 

[5cent]

I took a sharp razor blade to the inner honey comb parts of the grill where the factory air inlet was for the intake.
Just outline the honeycomb a few times and take a screwdriver and hammer to the center of the blocked honeycomb. They'll pop through.
It looks clean as well.

Ok thanks. Did you do any data logging and see if you was get cooler or more air?

Sent from my SAMSUNG-SM-G900A using Tapatalk

 

[Obsol3te]

Ok thanks. Did you do any data logging and see if you was get cooler or more air?

Sent from my SAMSUNG-SM-G900A using Tapatalk

I can't remember the exact results. I'm running a completely different setup now. But it did help drop IAT's after sitting in traffic a bit quicker.
I commented about this on a thread in the v6 section a while back if you could dig it up.
I believe i posted results there.

Nope, no specific IAT results. But there's a picture

http://www.mustang6g.com/forums/showthread.php?t=42372

 

[EcoBoostang]

Sorry I saw the title of the thread and had to... LOL

 

[SVOv2.0]

Swiss Cheese Grille Mode

I couldn't have all the folks with GT grilles have all the fun! Unfortunately, the V6/Ecoboost grilles are constructed differently, so its much harder to perform the Grille delete mod.

I compromised, and performed the Swiss Cheese Grille Mod since I was also concerned about the aero and debris. Heck, with the popularity of the grille delete kits, maybe I'm being too cautious.

I used the existing "dimples" as guides. I then used progressively larger drill bits to get to the size I wanted.

 

[5cent]

Boom.

Sent from my SAMSUNG-SM-G900A using Tapatalk

Sponsored