Adding a Sub to Base Stereo

[sharp21]

That's the magnet on your factory deck speakers? Looks normal, mine are about the diameter of a 50 cent piece and about 1.5" deep... Nothing near traditional magnet size.

Rears are stockers for sure.

I'm thinking of changing to a 5 channel amp and redoing the fronts and rears...

S.

Sponsored

 

[vnzbd]

You could just move the fuse location from the amp to the battery. Also find a grommet for where the power wire exits the fender. Trouble down the road. Enjoy the bass!

 

[zxd9]

Where the wire comes up into the engine bay you might want to put a grommet on the hole so the metal doesn't wear through the wire over time.

 

[sharp21]

Is there another hole I can use? I'd like to install struts, so I'll move the fuse and tidy it up when I install those

 

[ohbuckeyes]

Is there another hole I can use? I'd like to install struts, so I'll move the fuse and tidy it up when I install those

For my Airride I used the same nipple hole in the firewall wiring he did, but routed my wiring up closer to the engine bay, it comes up through the heat padding stuff.

 

[5ABI VT]

Pull out the battery just run the wire up through the drain piece and into the battery compartment. It's what I did.. Let me find the pics

 

[sharp21]

Both good ideas. I'll order up the struts next then make the changes when I install them
S.

 

[5ABI VT]

knew I posted it somewhere. Here are my pics. From the grommet going through the firewall, theres that black plastic thing above it... I routed the wire through there into the battery compartment (below the battery tray). Taped it along the deeper area so the tray wont interfere then put it back in. Completely invisible

http://www.mustang6g.com/forums/showthread.php?t=38310

Sponsored