20x10 square ?

[jbailer]

Is there any reason a square 20x10 +37 offset wouldn't work? They say rear only.

Sponsored

 

[DoingOK]

I went with 20x10 +45 Advan GT's in a square setup. Depending on my Airlift front strut, I may need a small 5mm spacer. Wheels were shipped from Japan today. Should be 7-10 days until I receive them.

 

[Need4SpeedMotors]

looking badass [MENTION=20543]JerzysIS6g[/MENTION]
[MENTION=15518]jbailer[/MENTION] the reason why is the front may need a small spacer to have the cap fit over the grease cap. Also depends on what wheel your looking at.

 

[c_reber]

Hopefully mounting up my 20x10 (+38 I think, can't remember offset) Hotchkis Y-sport wheels tomorrow. Test fit wheels last week and fit fine. Would need a small spacer to fit the center caps. Why do the 20's STILL look small on this car?

I went a little large on the tire, but should be fine on stock suspension. 295/30/20 MPSS should be here tomorrow.

 

[DoingOK]

My buddy in Japan sent me a quick pic of my actual wheels.....they shipped out today.

 

[Need4SpeedMotors]

My buddy in Japan sent me a quick pic of my actual wheels.....they shipped out today.

Oh yes come to pappa, well to you even though if you want to be generous I can borrow them for say 3 months

 

[DoingOK]

Sure......just gently bathe and wax weekly and you gotta deal. ;-)

 

[Need4SpeedMotors]

im soo down !

 

[DoingOK]

.....and ouch, just purchased four Michelin Super Sports in a 285x35x20 size. They are getting a little pricey nowadays ($1,521.36).

 

[Need4SpeedMotors]

.....and ouch, just purchased four Michelin Super Sports in a 285x35x20 size. They are getting a little pricey nowadays ($1,521.36).

Your telling me brotha.

 

[c_reber]

Got my 20x10's mounted. 20x10 hotchkis Y sport with 295/30/20 MPSS tires all around, no rubbing, but still stock suspension (as you can tell from the wheel gap lol.)

Anyone have a way to get a smaller dust-cap on the front? Can I pound it in and dent/bend it a little with a hammer? I don't want to run a spacer in front if I don't have to. Its just the center caps won't fit in front.

 

[BigEasyGT]

Hit the grease caps with a hammer a few times and you should be able to get the center caps on.

 

[Need4SpeedMotors]

Dont hit it love tap it man lol its a matter of mm.

 

[BigEasyGT]

Love tapping took too long and I'm impatient lol. Gave it a decent, but not crazy, whack and the caps went right on.

 

[aggieStang]

Got my 20x10's mounted. 20x10 hotchkis Y sport with 295/30/20 MPSS tires all around, no rubbing, but still stock suspension (as you can tell from the wheel gap lol.)

Anyone have a way to get a smaller dust-cap on the front? Can I pound it in and dent/bend it a little with a hammer? I don't want to run a spacer in front if I don't have to. Its just the center caps won't fit in

Needs moar low!!!

Sponsored