2021 with cs14 wheels 20x11 out back have too much poke for me

[kg2194]

I have ordered another 2 20x0.5 for the rear. these are 20x11 +50 out back with 295 35 20 and they poke just a bit too much for my taste! just a post more to inform others my issues.

Sponsored

 

[NightmareMoon]

add a little camber.

 

[Champale]

When looking at the car from behind, the wheel and tire are actually sitting outside the fender lip? 20x11 ET50 is pretty common fitment so that is suprising.

 

[RonsterGT]

When looking at the car from behind, the wheel and tire are actually sitting outside the fender lip? 20x11 ET50 is pretty common fitment so that is suprising.

This.

 

[shogun32]

your pictures don't show poke at all - try taking pictures along the bodyline. Yes I think you'll find that the bulge in the tire is proud of a plumb-line dropped from the fender. But lots of us would say your front wheels are drastically too far recessed.

-1.2 to -1.5 camber on the rear should help a little bit. See if those rears are available in 10 or 10.5.

For x11 to truly tuck you need et60 I think.

 

[EFI]

they poke just a bit too much for my taste!

I respect your opinion on what you like/dislike, but I don't think your use of "poke" is accurate. As others said 11" wide wheels with +50 offset is pretty common and does not poke, especially with a narrow 295 tire.

Either that or your alignment is way out of whack and one side sits out further than the other due to a mechanical issue.

 

[Brigalow]

I respect your opinion on what you like/dislike, but I don't think your use of "poke" is accurate. As others said 11" wide wheels with +50 offset is pretty common and does not poke, especially with a narrow 295 tire.

Either that or your alignment is way out of whack and one side sits out further than the other due to a mechanical issue.

I have the Shelby CS14 on my 2021 GT with 295 35 20 Michelin and had to set camber angle at - 2 deg to get them inside the guard.

Sponsored