z06psi
Well-Known Member
- Joined
- May 15, 2015
- Threads
- 72
- Messages
- 4,157
- Reaction score
- 1,394
- Location
- Evans, GA.
- First Name
- Andrew
- Vehicle(s)
- The pot stirrer
- Thread starter
- #1
Gents,
I need two sources for switched 12V. One in the passenger kick panel and the other in the engine compartment fuse block. I have a voltage draw on the battery.
I have so much wiring between the boost stuff, air ride, and stereo that I have a wire draining my stuff.
I already measured between ground and cannot get an amp reading with the car off so I just unplugged everything from the system because it was not allowing the car to start.
The fuse taps I have in read 0V after the car is off and closed but for some reason I am still getting a draw.
TIA,
Andrew
I need two sources for switched 12V. One in the passenger kick panel and the other in the engine compartment fuse block. I have a voltage draw on the battery.
I have so much wiring between the boost stuff, air ride, and stereo that I have a wire draining my stuff.
I already measured between ground and cannot get an amp reading with the car off so I just unplugged everything from the system because it was not allowing the car to start.
The fuse taps I have in read 0V after the car is off and closed but for some reason I am still getting a draw.
TIA,
Andrew
Sponsored