head gaskets

About to take my car in for an engine rebuild. For sure know my head gaskets are bad and i had just done the Timing chain kit with new phasers, bullit tensioners and OPGs. I am running rebuilt 10R80, 3.73 in my rear. Engine is pretty stock but wanting to get everyones input on a good rebuild kit...

Alright, hey guys I’m pretty new around here and I’d like to show off my 2016 Ruby Red Mustang GT. I occasionally track the car about 3 or 4 times a year and a lot of road trips. I Recently built my 2016 5.0 coyote because of bad rings on the original motor. So i went with a brand new Gen 3...

Hi Forum, Which is the required torque for the 2013-14 Coyote Head Bolts with the 11mm Bolts. I have only been able to find information about the earlier 12mm Bolts. Thanks in advance Ueberhopft

Hello! Longtime lurker, first-time poster. I’ve searched this forum and others extensively, so forgive me if this topic has already been covered and I missed it. I’m trying to gauge how prevalent head gasket failures are on the 2.3-liter EcoBoost engine. Is this a common occurrence or an...

Seriously considering getting a gen3 coyote short block, but would be using my gen2 heads. I know the head-bolts are different (11mm vs 12mm). I've heard I can just pickup any gen3 head stud kit and put my gen2 heads right on, is that true, and is it just any generic headbolt kit for a gen3...

I purchased my 2018 GT as a RAV (with an extended warranty) just a few months ago. Ran great for the first month or so. But, a couple weeks ago, I was driving around town and my car started running rough, and the low oil pressure alarm blinked. Pulled over, checked oil, looked good. I took it...

Hello guys! My 2016 Ecoboost ghost misfires and shakes a bit when RPM drops after cold start until the engine warms up after that it runs well without any issue plus It doesn't give me any trouble codes, this happened after a head-gasket replacement and engine rebuild. Listen closely to the...

FR3E-6083-CA FR3E-6051-CA FR3E-6051-F FR3E-6051-A