Search results

I have been looking around trying to find different aftermarket solutions for a rear end for a 2015 Mustang GT. I've been able to find watsonracing.com . Any suggestions?

I'm currently trying to take out the gas tank, and I've run into an issue trying to remove one of the electric connectors. This is on the passenger side and I believe it is the sending unit. There is a grey tab on the back by the wires that can be depressed. But it looks like something needs...

I was doing some work on my 2015 Mustang GT today. I'm the 4th owner, and some work has been done to the car before me. Anyway, behind the intake manifold there is a wire bundle that runs behind it. There are 2 plugs back there that are not plugged into anything. They remind me of an O2...

I was hoping to find a stamp on the inside of the rims telling me what the offset is. But this is what I've found. Can anyone make any sense of these stamps?

Is there a way to monitor coil packs? I'm trying to chase down some misfires. while the codes do give me as an example cylinder 6 and 2 and a few others that come and go. Can this be monitored with HP Tuners or on a dyno? Regards, Ashtar

Hello Everyone, I am currently looking for troubleshooting suggestions. The car: 2015 Mustang gt with a Hellion twin turbo kit. The issue: When I start the car everything is normal. Normal idle (800)on a cold start. I'll let the car warm up, and when it reaches 180+ temp on head...

Looking for the thread pitch and size for the engine mount bolts? For a 2015 Mustang GT. Trying to see if they are SAE or???

I currently have a 2015 GT PP1, but this seems to be an after market front bumper. Any ideas on what it is?

SCT x4 Unmarried, with 5 unlocks. PN 7015 (Ford) 300.00

Hello All, So this has been a "Thing" for me. The short of it is, I've had to add Cat's back on to the car to get it to pass emissions. Right now I am trying to get the Oxygen Sensor and Oxygen Sensor Heater to check in. They show as incomplete. Everything else has checked and shows good...

Hello All, I am looking for some input. I currently have a 2015 GT PP, that makes around 800 hp. The MT82 is being replaced with a T-56 Mag XL. The current rear is a 3.55, and the clutch is being changed up to support the HP, as is the drive shaft. The haft shafts will be done with the rear...

Got a new leak... 2015 Mustang GT So I've been chasing down a leak on the transmission area. https://photos.app.goo.gl/bpW65LQ6pVU23mW3A Let me know if ya all can see the video. Back story. Looks like it was coming from the drain plug area. Took off the drain plug and it looks like someone...

Looking to replace the rear seal in my MT82 transmission. (2015 mustang GT) I've got the drive shaft out, and such. I'm looking to see where I need to go next?

I've been looking for a few hours now trying to find the part number I need to replace the rear seal on a 2015 mustang GT MT-82 transmission seal. Also known as a output shaft seal. Thanks in advance.

Eibach Sportline Lowering Springs. About 8000 miles on them. Bought the Mustang with them on it. Too low for my liking. I've already put on a set of Ford Performance street lowering springs. 190, shipped to you within the states. PM me. 2015 GT with Performance package. With the Eibach...