Search results

I cranked the car this morning and was welcomed with a wrench light and advised to check owner’s manual. Upon driving I quickly noticed it would only shift into even gears. I limped to the dealer, who checked for codes. However when they cranked the car it did not show any codes for this issue...

Hello. I have an aftermarket sound system in my 2020 GT500 (b&o system). I have a PAC controller (attached between the factory amp and head unit) going to aftermarket amps powering the panel/door speakers and sub (all aftermarket). I am also planning to add an aftermarket eq (RF dsr1). I am...

I have a 2020 GT500 with the B&O system. A local installer is attempting to install several new components, but they are running into some difficulties. The components are: - JL The Fix 86 - JL XD600 amp - Alpine X Series Components - Alpine R series coaxial (rear deck) - Infinity mids - JL w1...

Audio folks: I decided to upgrade the b&o audio system. I went to the local audio shop today I was quoted on the following: - Apline R rear deck speakers (coaxial), X series components (lower door and tweeter) - Infiniti 2in. mids  - JL 10 sub W-1 installed in existing trunk enclosure, after...

SOLD

Has anyone other than MMR (or their affiliates...Bama) seen these fail? If so, under what conditions? Burnouts on the rev limiter, etc.? Thanks for the update.

I am planning to install a DSS aluminum driveshaft on my car tomorrow. I am looking for tips for anyone who has already done this. A couple of questions: Is it necessary to remove the exhaust or should I be able to slide the old and new shaft out/in the back half of the car? What are...

First off, if anyone near Mississippi would like to trade their 6r80 for my MT-80 (w/ MGW and McLeod Rxt - no power shifting, perfect condition), let me know by PM. Anyone looked into acquiring the parts to make this work? How expensive would this be on average? Thanks.

I am selling a new never-installed JPC breather kit for TVS applications. $55 shipped to continental U.S. Please PM if interested.

I am selling a black JLT catch can with TVS fittings. I bought this for an n/a setup and then converted it with the JLT Tvs adapter kit. I may be able to find the n/a hoses too, but I'm not sure. $100 shipped in continental U.S. Please PM if interested.

At the recommendation of another s550 owner, I order a pcv valve for an Ecoboost Truck from Tasca to install on the passenger side. I am planning to install this and continue to run my JLT catch can, which will hopefully eliminate almost all of the oil making it into the intake (the JLT alone...

I am selling the hi-flow cats off of my SW long tube headers. I decided to go castless. If you are planning to buy SW catted headers you can buy the off-road version and insert these cats in the cat delete section. No welding required or additional fabrication required. I think SW charges...

Hey, guys. I've noticed that after installing LT headers they tend to pop every few seconds after turning the car off for about 5 minutes. I know it is the header cooling off, but I just wanted to make sure it is normal to have it doing it this much, i.e., I want to make sure it's not running...

I'm planning to connect a Ctek batter tender up to my battery, but I noticed that we don't have a secondary post on our factory positive terminal to hook accessories to. Where are you guys attaching to? Are you changing the connector or is there some way to run a wire from the positive post as...

Does anyone with the magnaflow street series catback find their exhaust to be a little too quiet and/or wish they had gone with the competition series?

Does anyone near MS want to trade their Magnaflow street catback for my competition series? The comp series is a little too loud for my taste since installing headers. Not interested in other systems. Thanks.

Anyone using a breather setup in place of the factory pcv system? I bought a breather kit, but it looks near impossible to put a cap on the lower intake inlet behind the blower (and tighten it down). Is it possible to just put a plug in the hose running from the rear inlet and leav the hose...

Have you guys heard about an "issue" with the timing sprocket on the S550? Apparently the 15s have a thinner, weaker sprocket relative to the 11-14 cars. Someone sent me a post from fb of a guy with a TVS car that had a sprocket break. Are you guys upgrading to a billet sprocket. I already...

Okay, guys. I finally got my stage 2 VMP 2015 tuned this week and it is freaking ridiculous. First of all, the VMP components are excellent and the service provided by Justin and his guys throughout the process was fantastic. The blower and all components were installed locally by...

I flushed the stock tranny fluid and used RP fluid. I used the better part of 4qt. I have seen where others suggested it took only 3qt. Has anyone else with a PP car changed the stock fluid? How much did you use? Side note- I also added an MGW shifter. The shifter is phenomenal, but I am...