Search results

Howdy everyone! Long time no post. I was considering buying a full IRS drop out of a PP car to swap onto my base GT (kinda serious, kinda not, still researching). I keep finding myself ask the question, are there any differences between 15-17 and 18-23 car subframes (the cradle itself?). I...

Hello fellow M6G nerds, My car hasn’t moved in weeks because of life, but I noticed some oil residue on the AC compressor, the passenger side of the rack assembly, and on the timing cover on top of the crank pulley. It isn’t dripping and has been there for a while (it’s collected some shmoo...

Hey everyone, Washing car today for the first time in forever, took wheels off for cleaning and noticed after 13k the front Michelin PSS are wearing a little more aggressively on the inner shoulder tread block. The car was set to have just the slightest bit of toe in and -1.6 negative camber...

We drive (relatively) high HP RWD vehicles. Rear tires will burn themselves up before the fronts. I’m just thinking about rubber again. I have a Michelin PSS set up on factory GT350 wheels. Rear tires are obviously getting down to the wear bars much faster than the fronts. My tires are dated...

Hey everyone, I’m a victim of the IMRC actuating rod failures and have to start shopping around. My 5.0 is a 37k mile 6sp MT82 with a stock drivetrain but half of the Steeda/BMR catalogs thrown at it. Anyways, has Ford updated the intake manifolds for Gen 2s? Are the rods stronger now? I’m...

Hey everyone, Long story short my car is sitting uneven in the front. It never truly bothered me until I started trying to stuff the OEM GT350 wheels on my base 17 GT. With that said, they fit, with no rubbing except for on the front driver tire. My car needs an alignment and has the...

Hey everyone, I am likely beating a dead horse at this point but I have a set of GT350 wheels with the OEM Michelin PSS with 2.5/3mm of tread left that obviously need to be replaced. Specs: Front 19x10.5", 30mm offset, 60.5lb (with 295/35/19 stock tire) Rear 19x11", 62mm offset, 61lb (with...

Hello everyone! I’ve got a gnarly clunking noise at low speeds while hitting bumps and turning. Car is a base 17 GT 6MT lowered on Steeda progressives. Long story short I couldn’t figure out what it was with the front end assembled and now I have a strut/knuckle assembly hanging freely in my...