Search results

Installing the steeda bump steer kit tonight and was wondering if anyone else that has done this has any tips or tricks to have the toe aligned as close as possible. I'm going for an alignment friday but wanted to get this done today. How many washers did you use top/bottom? Any macgyver...

@nastang87xx Wtf god damnnn!

@mustangguy88 My driver side air is warm and passenger side is cold... do you know off hand what part failure causes this or at least a place for me to start looking?

Idk about that but his cars way too modified for the dealer not to go back and fourth with him about whether his mods caused it or not, no one wants that. In the end hed probably get it done but after how much of a headache, plus we already said we'd rather do our own.

@tokuzumi 15 and 16 model years are out of warranty now, its 3 years/36k

Seems to be dual zone mostly, I had a 2016 v6 base 45k miles single zone and it never went out. Now I have a Premium 2016 gt with 25k miles with dual zone and one side has already failed.

@mustangguy88 Please do as I'd rather do this myself then trust some kid that doesnt give a shit about my car.

Driverside just went out 2 weeks ago, passenger side soon, and out of warranty... 2016 25k miles Can you get the extended warranty after yours expires?

Haha I knew it!!!!

Ya manbearpig is right, if you know someone with a 15-17 try throwing their TB on your car and see if the clicking goes away. Then your going to have to take off the IM and make sure the knock sensor is connected and wires are not chewed up. If wires look good and all fuses are pushed in(just...

Picture a fellow mustang owner took and edited...

You paid the extra $$ with the lund tune for the aftermarket mani right? Maybe the wire harness for the knock sensor got caught on something and wear and tear is exposing the wire and its shorting? See if you can have your buddy take the mani off to check the wire and connection. P.S. double...

What's the code number p***** You can monitor real time knock on the ngauge, I have an x4 and it's under datalog probably similar on ngauge. If its throwing a code for it then something's wrong with the sensor or wiring. Have you had the intake mani off before? The knock sensor(theres 2) is...

Your getting knock that's showing in a datalog or are your getting a CEL regarding knock sensor(didnt know there was one). If your throwing a code about the knock sensor then maybe one of the sensors itself is bad or got disconnected. If your seeing knock in a datalog, how much? Low rpm knock is...

That's odd, almost sounds like the fuse click when you turn the heated/ac seats on.

@BrianGT2015 How do you clean that shit out of a plastic intake? I know the old metal ones you can burn it out but do you know a way without just scraping?

The imrc closes under low load like crushing around town to give a little bump to low end torque. With imrcs not locked you might feel a small hesitation as you floor the car as they switch from closed to open. Tuners prefer the lock out as it's easier to tune. Locking them out also prevents an...

Did you test the corn in your tank? Maybe it's way lower than 85% ethanol.

+1 for sway bar endlinks, happened to me but heard clunking over bumps Check the rear axle nuts also, should be 180 ft-lbs if I remember correctly but double check that, one of mine backed out to 70 ft-lbs.

At the end of the day your going to have to make up your own mind. Here's the video that sold me on my exhaust... one more video wont hurt lmao