Search results

I missed a very popular vendors 4th of July sale as I was still in the process of researching what suspension setup I wanted to go with. Once I had decided I saw that the prices had gone back up. That is a "me issue" for not acting during the sale. So I have my parts list here and decided that I...

Well just something that makes you go Hmmm.... 8 year, 100k mile policy with a VA address - $1,440. In FL the identical policy is $3,195. The law regulates extended warranties in FL and it falls under insurance regulations. You must have a FL licence to sell it here. No online sales without that...

I have a 16 at 21k miles. Evaporator core at 11k and steering wheel at 15k.

57 here. I much prefer the understated look. Like the Bullitt minus the rear panel. V6 owner here so I am in the vast minority.... I started simple with a base model, no trunk mounted blade spoiler for the cleanest look. Obliviously no 5.0 badges (I know...no 5.0 engine) or hood vents. I don.t...

I have a 2016 V6, 18k miles and the warranty is about to expire. I do have 3 years to pay as I took a 72 month - 0% Ford Credit loan. I have chosen to make money elsewhere vs. paying off the car at this time. I am concerned about the factory warranty expiring and am done modding the car. I have...

Car and Driver this month has a good article on this very subject. They test 4 vehicles. The difference is minor for most producing 0-60 and 1/4 mile testing with approximately a .1 second improvement at 93. The one vehicle that has a major impact is the v6 twin turbo ecoboost pick up truck...

Did a quick search and found nothing on what I believe to be American Muscles in house brand "SR". I am changing out my front springs only with the BMR 089 min drop. I have spoken to BMR directly about this and the move comes recommended by them stating that is why they sell the spring...

More thoughts is that on the stance thread people have mixed and matched a variety of the BMR springs and it is not discouraged by BMR. Curious...

That would be my thought too. However BMR even has a picture (GT) with stocks on back and the 89 on the front. Saw a few on the BMR stance thread as well.At 170lb I would not think that could be far off from stock. Just thinking at this point. I do greatly appreciate the input.

I have been doing some more research, and thread reading and think I may just try the BMR sp089 springs in front without replacing the rears and see if I like the look. I am more concerned about the front wheel gap than the actual lowering. Mine looks like a 4wd in front! If I stay with the...

Thank you gentlemen.

I was planing to do an install of the Ford PP damper set (M-18000-F) on my V6 with the BMR SP763 Springs. Reading on AmericanMuscle and CJPP that specifically state that these dampers as not to be used on the V6 model. I would have expected the suspensions to be the same so I am curious to why...

USMC, quite the list of mods you have! The Solo exhaust looks very interesting. Why did yo opt for the 3" over the 2.5"? Are you planning on boosting?

Cyclonetron, That was my concern was the loss of the low end torque. Interesting that you felt it right away. Based on your exhaust swap I would not think you were just caught up with the exhaust tone. I am not a racer by any means and the majority of the time I am under 4k rpms. I would like to...

Had some thoughts/questions on the exhaust diameter for our V6s. Ford goes with the 2.25" as well as Borla. It is my impression that Borla does as much if not more R&D on their products. Their claim is the exhaust diameter they use is the best for exhaust scavenging. Ford may have had this same...

When I ran GT with the H-pipe (MRT) I had zero drone. I did have some rasp over 4k rpm though. I don't drive there often so not the biggest deal for me. Expected it to go away with the Borla Touring. Better but not gone at WOT.

Good looking ride Jesse! I had the exact exhaust setup for a while, big improvement over stock. Recently went to a Ford Racing Borla Touring, a little on the loud side with my rear seat delete. Good luck with your mods.

Having my evaporator core go at 3k miles and now a steering wheel replaced at 10k miles on my 2016 Mustang, can't say I will be buying a new Ford anytime soon. As far as rattles I feel like I am tracking down a new one every week. Should have opted for the extended warranty for this one. Or if...

Nice install. I like the simplistic approach.

Saw this on the local Clist. No affiliation. https://treasure.craigslist.org/ele/d/mustang-factory-subwoofer/6624651021.html