yoz
Member
- Joined
- Jan 24, 2020
- Threads
- 0
- Messages
- 5
- Reaction score
- 2
- Location
- Poznan, Poland
- First Name
- Wojciech
- Vehicle(s)
- Mustang S550 2015, 2.3 ecoboost
Got few questions:
1) are you able to post WPT-1279 pin numbering that you use?
2) you have marked that pins 11, 12, 13, 14 are not used, and than that CAN+/- should be feed to PIN 12 and 13.
On drivers side seat 4 pins are missing - I assume it is 11-14 (but which way count?) On passenger side pins 12 i 13 are there. On your photo it seams that you have cut into cable of 12 and 13th - but I think I can feed directly those 2 pins (just run cable from bezel to seat pigtail) - am I right?
3) Do I need to activate H/C in forscan? actually buttons lights up while pressing (didn't make any connection to seat yet).
Making all simple - what need to be done:
1) make 12 wire harness + 2 loose cables on passenger pigtail pin 12 and 13
2) passenger seat pin 12 and 13 feed from bezel 17 and 18 (loose cables from passenger seat run to bezel instead of driver seat)
3) Cut pin 9 wire in seat connector and splice it with pin 1 (connect green/red wire with purple/red)
and thats it? am I correct?
1) are you able to post WPT-1279 pin numbering that you use?
2) you have marked that pins 11, 12, 13, 14 are not used, and than that CAN+/- should be feed to PIN 12 and 13.
On drivers side seat 4 pins are missing - I assume it is 11-14 (but which way count?) On passenger side pins 12 i 13 are there. On your photo it seams that you have cut into cable of 12 and 13th - but I think I can feed directly those 2 pins (just run cable from bezel to seat pigtail) - am I right?
3) Do I need to activate H/C in forscan? actually buttons lights up while pressing (didn't make any connection to seat yet).
Making all simple - what need to be done:
1) make 12 wire harness + 2 loose cables on passenger pigtail pin 12 and 13
2) passenger seat pin 12 and 13 feed from bezel 17 and 18 (loose cables from passenger seat run to bezel instead of driver seat)
3) Cut pin 9 wire in seat connector and splice it with pin 1 (connect green/red wire with purple/red)
and thats it? am I correct?
Sponsored