Hurst Axle back

[bubba]

Anyone here have one of these? Was kind of an impulse buy, but I picked one up for super cheap, new in the box. It appears they've been discontinued, but there's a full catback that's still available. I had been looking at the MBRP street catback or Magnaflow comp. axleback.

https://www.summitracing.com/parts/...hvnAItmJit087dyxmI8-xuigj2dja4eUmLRoCJa_w_wcB

Sponsored

 

[Ruby red GT]

I've heard them in person. Not bad nice deep tone.

 

[Mustang_Lou]

Look like Magnaflow mufflers without the name ... should sound good.

 

[bubba]

I guess they're made by Flowmaster. Could only find a couple of sound clips, but they were all the complete axle back, not the axleback.

I got this one for $429 shipped NIB, had I not stunbled across this deal, I would've went with one of the other 2 I mentioned above.

 

[bubba]

It looks like I can easily add the Flowmaster scavenger series x-pipe later on down the line and it'll be a direct fit.

 

[bubba]

I'd say they sound pretty good. Nice deep tone outside the car. Fairly quiet inside. Can always increase the volume later on with an x or h pipe.

Stock:



Hurst Axleback:

 

[Orange_cru$h]

I have one with H pipe. Its not loud at all and has a muscle car sound to it. Freeway wont drone but you do get low notes at 1.6krpms that might bother if you get the engine to ludge in to high of a gear (auto). Basically is a flowmaster hushpower or laminarflow muffler with hurst design.

Here's my crappy vid. But you get the sound.

 

[bubba]

I have one with H pipe. Its not loud at all and has a muscle car sound to it. Freeway wont drone but you do get low notes at 1.6krpms that might bother if you get the engine to ludge in to high of a gear (auto). Basically is a flowmaster hushpower or laminarflow muffler with hurst design.

Here's my crappy vid. But you get the sound.

Yea I'd say they sound pretty good with an H pipe. did you ever get a chance to swap in an x pipe to see how they sound?

Also, when I installed mine, they seem to favor the inner side of the exhaust cutout. Anyway to get them in a little more evenly on both sides of the cutout?

Thanks!

 

[bubba]

Did a little rev video this evening. Sounds good.

Sponsored