foghat
Well-Known Member
Mine was doing this right after install. there are three screws that hold the lockcollar in place - I had to fiddle a bit with the collar alignment. Now, about 5/6 months later, mine has started making noise again. It is the lockout collar.Hey guys. so my shifter has started developing a rattle at high revs. Pretty sure its the lockout collar (I have the stock one) and I thought I read somewhere here someone else had the same issue.
I can only imagine as the NVH has increased the vibrations are now noticeable through the shifter.
Any ideas and guideance? I note my lock out collar is a little grindy kind of noise when I use it
I can't remember for sure, but I think you just need to pop the boot (the chrome bezel) out of the console and re-align/tighten the bolts that hold the collar in place. If the screws can't be accessed by just popping the boot, the center stack will need to be removed.
I have a barton aluminium lockout collar I am going to try - not sure if that would make the same noises. Might be worth putting some loctite blue on the screws. I am going to try the aluminium collar without and see what happens.
Sponsored