Whipple goes 9's.

[Reds197]

View attachment 78083

DA is 7200 but I still managed a 9. Still dialing in the sixty. Mods are in video link. Car is remote tuned by Ken B at Palm Beach Dyno.

[ame]

Sponsored

 

[terryj]

Nice. No small accomplishment at that elevation. Your car is making good power.

 

[zaquhree]

I need that 60' in my life

 

[PowerAdderGT]

Congratz Curtis!

 

[Super Werty]

Can you get a acceleration video from inside?

 

[PowerAdderGT]

Is that with the Circle D 2B?

 

[Reds197]

I went with a Precision Industries 3500. It is hitting a little to hard and blowing the tires off when the prep sucks. I have only made 5 passes with it. I finally figured out how to leave a little softer with out spinning. I think I can go low 1.40.

 

[Burnin4]

very nice, congrats!

 

[BDMACH1]

Congrats Curtis, thats impressive for that elevation!

 

[Yellow]

Nice. What tires are you running ?

 

[Ultrakla$$ic]

Car sounds like it never ran out of steam but kept pulling HARD all the way through the traps!!!!!:eyebulge::cheers:

 

[Excelerater]

Can see this you can datalog the RPM on the runs ?

you may need more pump pressure or tighter clutches w the tranny
it sounds odd at the shift and gives me the impression
that your loosing ET..

 

[zaquhree]

[ame]

as a reference this is how my shifts sound. these almost sound like the trans is not properly engaging causing that loooooooooooooong shift. the older 2015 6R80 tunes used to sound like this when they first got into the 2015 PCM to my knowledge.

I would take a close look at what the trans is doing on the shifts and you can probably find a crumb trail

 

[jasonstang]

That 1-2nd shift is soft.

 

[smokinzx14r]

Get that trans tuned .. Mine hits so hard after setting the firmness and TQ management it will take your head off... Plus your trans will last much longer and run cooler ...

I have to say you got that car flying at 7000 DA !!! Just think what it would run at sea level !!!

Sponsored