BlkMach10510
Well-Known Member
- Thread starter
- #1
I was wondering if anyone knows where I can find how to get the screws without the shifter?
Sponsored
No but one is close to being stripped, lol.It’s so weird I can’t find a blow up that shows the screw sizes or part number. I assume you dropped one changing out the shifter?
Pardon my ignorance here but how do you strip a bolt in an automatic that you just push a button and pull back? Just asking because I have one too.No but one is close to being stripped, lol.
Changing out the shifter there are those two little screws that disconnect it.Pardon my stupidity here but how do you strip a bolt in an automatic that you just push a button and pull back? Just asking because I have one too.
Those screws only have about 1/16" of thread engagement in the shift rod they go into so it's not difficult to strip the threads but IMO the screws are harder than the threads in the hollow rod that they thread into so it's more likely that the threads in the hollow rod will strip before the threads on the screws will if over tightened.Pardon my ignorance here but how do you strip a bolt in an automatic that you just push a button and pull back? Just asking because I have one too.