UPR Oil Separator list for everyone interested.

[GT Pony]

Evening,

Was going to install my gt catch can (the one that mounts) but it seemed the pipes were excessively long. The dirty air pipe is probably 5-6 inches too long and will require a hell of a lot of bending to connect. Is this normal. Anyone care to measure the pipe length on theirs?

Cheers

Which remote mount location do you have? Here's mine with the UPR can that mounts near the top RH side of the radiator. The hoses seemed the right length in my case.

Sponsored

 

[Melbnut]

Which remote mount location do you have? Here's mine with the UPR can that mounts near the top RH side of the radiator. The hoses seemed the right length in my case.

Same as this one. I will do it again tonight and put a pic up. Seems far longer than your picture

 

[Sharad]

Same as this one. I will do it again tonight and put a pic up. Seems far longer than your picture

Hose ends are 5/8" Barbed fittings. You can pull the hose off of one end, cut the hose to whichever length is aesthetically pleasing, and push the hose end back in. This only takes a minute or two.

 

[Melbnut]

Hose ends are 5/8" Barbed fittings. You can pull the hose off of one end, cut the hose to whichever length is aesthetically pleasing, and push the hose end back in. This only takes a minute or two.

Thanks. This applies to the pro series hoses as well?

 

[UPRjoe]

Thanks. This applies to the pro series hoses as well?

Yes, it does apply to the UPR Catch Can Pro-Series™ Braided Hose as well.

Joe

Sponsored