Sponsored

TPMS is out

Ratpack

Well-Known Member
Joined
Nov 19, 2024
Threads
22
Messages
112
Reaction score
59
Location
SC
First Name
Tim
Vehicle(s)
2015 Mustang GT Convertible
I searched but didn't really see anything like I have going on now. I have a 2015 GT Vert and just replaced all TPMS about a year and half ago. About two weeks, they all went blank and I get the warning on the dash. I tried to relearn them, but the first one would not relearn, so I couldn't continue. I understand sensors fail and if it was just one or two, I would look to replace those sensors, but all 4 went blank at once. Any idea what may have happened? I was just driving in a parking lot when it went out, so not even any spirited driving going on. Checked all the tires and pressures are pretty spot on requirement, so it isn't a pressure issue. Only thing out of the norm, is the battery for the car had died about a week before due to sitting, but I put a charger on it and it is fine now. No other issues with the car at all. I haven't tried my scan tool to see if there is a code yet, so I may do that. Otherwise, any ideas?
Sponsored

 

Skye

Well-Known Member
Joined
Jan 18, 2022
Threads
13
Messages
2,915
Reaction score
4,087
Location
≈39N
Vehicle(s)
"Skye" Mach1 N2144
Does your fob work to lock and unlock the car? If it does, that clears the car's receiver and associated wiring. The fob and TPMS sensors use the same frequencies, receiver and wiring.

The TPMS units were replaced. Where were they purchased from? Do you know the brand name? They were working for over a year though...

The battery was dead. How long had the car been sitting? How old is the battery? How long has it been since charging the battery? Can you explain why it failed? Have you had the battery and charging system checked since? Bad batteries or low voltage can make all kind of weirdness happen.
 

Attachments

OP
OP
Ratpack

Ratpack

Well-Known Member
Joined
Nov 19, 2024
Threads
22
Messages
112
Reaction score
59
Location
SC
First Name
Tim
Vehicle(s)
2015 Mustang GT Convertible
Does your fob work to lock and unlock the car? If it does, that clears the car's receiver and associated wiring. The fob and TPMS sensors use the same frequencies, receiver and wiring.

The TPMS units were replaced. Where were they purchased from? Do you know the brand name? They were working for over a year though...

The battery was dead. How long had the car been sitting? How old is the battery? How long has it been since charging the battery? Can you explain why it failed? Have you had the battery and charging system checked since? Bad batteries or low voltage can make all kind of weirdness happen.
The sensors are generic replacements and I do not remember the name. However, they have been working since I put them in with no issues at all. And as mentioned, I find it odd that all 4 would go out at the same exact moment. I believe it is more in the system than the sensors.

The FOB does work to lock and unlock the car, even remote start.

The car had been sitting for about a month or so with no starting or running. I normally keep a battery tender on the car but this time I did not. I have since corrected that and everything else woks fine, as far as I can tell.

I can check the battery age, I bought the car secondhand, so I am not sure when the battery was replaced.

Only other thing that has changed is while the car was sitting, I was replacing the door speakers and had the door panels off. Other than that, no changes to the car recently.
 

Skye

Well-Known Member
Joined
Jan 18, 2022
Threads
13
Messages
2,915
Reaction score
4,087
Location
≈39N
Vehicle(s)
"Skye" Mach1 N2144
So it seems the car has lost its memory of those sensors.

Ford's units auto-register after a short drive. Other sensors could behave differently. Your Ford training tool might not work with the generic sensors.

The battery situation reads like it is sorted.

One option is to confirm pressures are right and drive the car. See if the vehicle eventually picks them up.

A second option is to go to a tire shop and ask them to excite each sensor so they register again.
 
Last edited:
OP
OP
Ratpack

Ratpack

Well-Known Member
Joined
Nov 19, 2024
Threads
22
Messages
112
Reaction score
59
Location
SC
First Name
Tim
Vehicle(s)
2015 Mustang GT Convertible
So it seems the car has lost its memory of those sensors.

Ford's units auto-register after a short drive. Other sensors could behave differently. Your Ford training tool might not work with the generic sensors.

The battery situation reads like it is sorted.

One option is to confirm pressures are right and drive the car. See if the vehicle eventually picks them up.

A second option is to go to a tire shop and ask them to excite each sensor so they register again.
The sensors are aftermarket so they won't auto learn like the Ford ones will, at least I don't believe they will. My training tool worked on them when they were installed. I may try changing the battery in the training tool to ensure it has full power and try it again. Outside, I am not sure what is going on.
 

mindo389

Well-Known Member
Joined
Nov 28, 2019
Threads
9
Messages
348
Reaction score
439
Location
Louisiana
First Name
Charles
Vehicle(s)
2015 Mustang GT 5.0 50th AY Appearance Pkg.
Vehicle Showcase
1
I recently had the same issue. My front left stopped working, and when I went to re-learn it, it failed and the rest stopped working, also. The local tire shop tried to excite it but it didn't work. I ended up biting the bullet and buying 4 new sensors from them. And they installed them without charge.
Sponsored

 
 








Top