Torque specs for Procharger installation

[SBR70.3]

I am installing the HO kit with a P1x blower in my 2016 GT. The installation is going smoothly so far and the instructions are spot on with the exception of one detail. There are no torque specs! Anyone have these? I have the brackets and blower mounted, but don't want to go any further until i know I have the bolts torqued properly.

Thanks for the help!

Sponsored

 

[Dominant1]

Procharger CALL US AT 913-338-2886

 

[Jackson1320]

I am installing the HO kit with a P1x blower in my 2016 GT. The installation is going smoothly so far and the instructions are spot on with the exception of one detail. There are no torque specs! Anyone have these? I have the brackets and blower mounted, but don't want to go any further until i know I have the bolts torqued properly.

Thanks for the help!

Torque to tight

 

[Jay-rod427]

3.4 ugga duggas.

 

[fmc_smt]

Three turns past strip , back off one .

 

[Jackson1320]

I am installing the HO kit with a P1x blower in my 2016 GT. The installation is going smoothly so far and the instructions are spot on with the exception of one detail. There are no torque specs! Anyone have these? I have the brackets and blower mounted, but don't want to go any further until i know I have the bolts torqued properly.

Thanks for the help!

The bolts go into the same holes that would normally bolt on your timing cover correct? I just make them tight but if you want a torque spec I would look up torque specs for the timing cover

 

[SheepDog]

A crossed thread is a tight thread.

Sponsored