Stanginator install 2019 GT

[G STANG]

I was wondering if anyone has installed a front emblem on a 2019 GT 10A from underneath the car, I have access to a lift and all the videos I have seen call for unbolting the radiator and pushing it back and it still seems tight. Admittedly I am a novice at wrenching but it appears when shining a flashlight in the grill if I take off the belly pan it is a clear wide open shot to the emblem.

Sponsored

 

[MikeHTally]

Often there are ways to accomplish a task other than "by the book". I replaced a fog lamp on my C without removing the bumper cover. Just start digging. Be careful not to get trapped in your procedure.

 

[G STANG]

Search is your friend.
https://www.mustang6g.com/forums/threads/stanginator-emblem.34847/

Hey thanks for the link, I had seen this post and it is for an install on a 2016. I have also read that changes were made to the 2018/19. Other posts were of people removing the hood latch 2015/16/17 to install and this post was an alternative to that method. I was wondering if the changes that were made affected the access to the emblem from below as it did from above ie. not being able to access by removing the hood latch 2018/19 and having to move the radiator out of the way.

 

[mks]

Hey thanks for the link, I had seen this post and it is for an install on a 2016. I have also read that changes were made to the 2018/19. Other posts were of people removing the hood latch 2015/16/17 to install and this post was an alternative to that method. I was wondering if the changes that were made affected the access to the emblem from below as it did from above ie. not being able to access by removing the hood latch 2018/19 and having to move the radiator out of the way.

On the 18, I went in from underneath after removing the belly pan. Time consuming, but very easy.

 

[G STANG]

Thanks for the info.! I will definitely go this route rather than trying to unbolt the radiator.

Sponsored