Spacer on GT PP 2018

[Stephane4985]

Hi, I have a GT PP 2018 and I think it would look better if the wheel/tire would come out a little more than the factory setup. So I was looking for maybe adding spacers on the 4 corners. But I used my car as a daily even in the winter (Quebec) so I have concern that this will result in throwing more rocks and sand on the side wall of the car and damage the paint on the long run. Is there a size of spacers that give a better look without risking of damaging the paint?

I know there are some that add wheel guard, but I'm not sure I like the look with wheel guard.

Thanks
Stephane

Sponsored

 

[FruityJudy]

The way the body lines are on the mustang you may increase your chances a little but the risk of damaging the side, especially right in front of the rear tires, are already there. I would run spacers and if you are really concerned, get some paint protection film applied infront of the rear tires. A lot of guys say the 25mm front, 23mm rear is the best wheel spacer depth for PP mustangs. I run 25mm on all four but my rear is cambered pretty good so the poke is not noticable.

 

[NightmareMoon]

You’ll get rock chips on the rear quarter panel in front of the rear wheel if you run an aggressive offset. Some film protection would be a good idea. The rest of the car (door, front quarter panel) seem fine. Speaking from experience and ~40k miles of running non-stock wheel offsets.

 

[stangjp]

I have ppf in front of my rear fender and i put rock guards ont the front. 25mm front ans rear

Sponsored