Smooth intake tube?

[80FoxCoupe]

You’re out of luck until you decide to reach outside the Mustang bubble.
There’s several “POLYMER” options to be had.

If you know of anything that may work please post a link. Any help would be greatly appreciated.

Sponsored

 

[GregO]

If you know of anything that may work please post a link.

Poke around Roto-Fab ( Dodge & Pontiac maybe even Chevy….. yikes LOL)
Slot style MAF housings, check out PMAS 120mm lineup.
Hope this helps, your project looks great so far.

 

[Dapepper9]

Probably better off building something out of aluminum. Also, love the shaved edelbrock manifold, looks killer

 

[80FoxCoupe]

Probably better off building something out of aluminum. Also, love the shaved edelbrock manifold, looks killer

Lots more to the intake than exterior looks, lots of trick stuff on the inside.

 

[Dapepper9]

Lots more to the intake than exterior looks, lots of trick stuff on the inside.

Yeah after I commented I searched the mani and found your work lol. I actually did very similar recently though I didn’t extend it out the back like you did.

Sponsored