Swapped blade spoiler for PP spoiler

[Exodus5]

I decided I loved the Performance Pack spoiler so I found a take off spoiler in the correct “Iconic Silver” on EBay and today I swapped it out.
This process required removing the interior trunk trim panel, removing the 4 lock nuts on the spoiler studs and prying it up. There is a ton of 3M double sided tape, so I used the fishing line saw method. Lots of time spent cleaning up the tape residue and then retaping the PP spoiler and reattaching.

Sponsored

 

[bluebeastsrt]

looks good. I usually use a heat gun to break the old spoiler lose. Comes right off.

 

[larr12]

Looking good!

 

[Sivi70980]

Looks great! Love the PP spoiler.

 

[quikcolin]

I'm about to pull my PP2 spoiler tomorrow and install a GT350 track pack spoiler. Going to be extra carful when taking out the screws. I'm already nervous about dropping one into the trunk lol. Wish me luck

Looks good btw!

 

[br_an]

Looks good! I went through the same thing last summer when I swapped for a Ford Performace GT350 track pack spoiler. Used a heat gun and some fishing line to get the blade spoiler up. There really is a lot of tape under those.

 

[Exodus5]

I'm about to pull my PP2 spoiler tomorrow and install a GT350 track pack spoiler. Going to be extra carful when taking out the screws. I'm already nervous about dropping one into the trunk lol. Wish me luck

Looks good btw!

I was worried about the two on the ends, so I was more careful and put the trunk down most of the way to make it easier to keep the nut even if it fell off.
Then I went too quick on one of the middle two and almost dropped it down into the “in-between” area.

 

[br_an]

...
I'm already nervous about dropping one into the trunk lol...

I found CJ Pony Parts install video helpful when I did this. Tilt the trunk lid down when removing the nuts and you should be fine.

 

[Justgonna send it]

looks crazy good bro. did the holes on the PP spoiler match up with the blade holes or did you have to do any drilling

 

[TnWHTMARE]

Looks great! Been there done that and loved it.

 

[Exodus5]

looks crazy good bro. did the holes on the PP spoiler match up with the blade holes or did you have to do any drilling

All holes were the same between these two spoilers.

 

[GMONSTAH]

Nice, love seeing the PP spoiler in the rearview...

Sponsored