3rdRGR
Well-Known Member
- Thread starter
- #1
This is just an Axle back quad exhaust that came on my RS2. When I got it, it had baffle plates installed on the inside tips, which is how they come from the factory. I saw where folks pull the plates out, which I did. It went from a little too quiet to (sorry if I'm handing over my man card) a little too loud in some cases when you get on it, and like most here I like to get on it. So I've heard a few people have kept the baffle plates in, but used a hole saw to punch a hole in the baffle plate, theoretically finding a middle ground. Anyone here ever done this? If so, what was the hole size and how did it work out? Sort of one of those things that you do it and there is no undoing it so, just trying to see if anyone has experimented and had it work out. Thanks!
Sponsored
