Edwin
Well-Known Member
- Joined
- Feb 22, 2015
- Threads
- 9
- Messages
- 361
- Reaction score
- 150
- Location
- Butler, PA
- First Name
- Edwin
- Vehicle(s)
- 2015 Ecoboost Mustang - Triple Yellow
- Thread starter
- #46
Thanks, I didn't try heat although that may have made it loosen up a bit. It won't be able to be pulled off like vinyl but it might make it easier to sand off. It took me quite a while to sand the whole piece down. I'm sure there's probably a better way of doing it than by hand but I really wanted to make sure it turned out ok. So it takes some patience. I used a dremel to sand out the vent holes that were a little tricky getting in to and then went over the whole thing again to make sure all the lines were going the way I wanted. Then I cleaned it with a damp towel, dried it, prepped it with some alcohol and applied the Protectaclear. I really like how that stuff turned out, it's self leveling and after it dries you can't really tell it's even on there. But it'll keep it from tarnishing and getting fingerprints all over it.
Sponsored