YouEnvyMe
New Member
- Thread starter
- #1
Just bought a 2016 Mustang GT, Procharger d-1sc. Check engine light is on (code P0315) Crankshaft position sensor relearn. Have had to 2 performance shops, they are confused. First time trying to reset it, didn't even ask them to rev the car but said relearned, CEL blinked twice but never went off. Tried again, revd but failed, I have tried about 20 times with an SCT tuner, didn't work, wasted $450... Shops said they are doing more research and made a few calls while I was there but nothing so far. Asked if the clutch was replaced recently, it was not. This car is two days old to me so I don't have the best knowledge of it history. There is a full write up on the car from Blackdog performance but that tells me nothing abouts its history. Any questions to anything done to it, I will put the link below. Here's the weird part to me: I have also accessed the Engineering Mode on the dash cluster and the DTC section is BLANK!!!!! The car is not showing any codes active or in the history on the DTC screen. Does anyone have any ideas what could be causing this or has anyone ever dealt with this issue and how did you fix it??? Please help, I just want the damn light off. Not to mention, I cannot pass emissions with that light on! Thank you in advance for any help!
https://www.blackdogperformancecars...duct_id=29/category_id=31/mode=prod/prd29.htm
https://www.blackdogperformancecars...duct_id=29/category_id=31/mode=prod/prd29.htm
Sponsored