- Joined
- Oct 26, 2016
- Threads
- 242
- Messages
- 14,414
- Reaction score
- 2,229
- Location
- Los Angeles, California
- Website
- WWW.PKAutoDesign.com
- First Name
- Paul A.
- Vehicle(s)
- 2016 Shelby GT350 Tech Pack #G5531 Avalanche Grey
- Thread starter
- #391
Sponsored
i was hoping to see these on a 350. Did you go with R spec spacing? Can you cake some more photo from a little farther away.Personally, I can't say enough about Paul and his crew. I went there to have my new wheels installed (below) and needsless to say, I couldn't be happier with the service and the result. If you need a shop owner you can absolutely trust, Paul is your guy.
I can take some this weekend with a higher-res camera. I did 19x11 ET50 all around with a 25mm spacer and new ARP studs in front. I wanted a square setup since this car will see a lot of track time.i was hoping to see these on a 350. Did you go with R spec spacing? Can you cake some more photo from a little farther away.
Thanks man. For what your planning its a great set up. I'm thinking 11" front with ET25 and 11.5" rear with ET55. I assume I'd get more concave in the rear and front??I can take some this weekend with a higher-res camera. I did 19x11 ET50 all around with a 25mm spacer and new ARP studs in front. I wanted a square setup since this car will see a lot of track time.
Same concave actuallyThanks man. For what your planning its a great set up. I'm thinking 11" front with ET25 and 11.5" rear with ET55. I assume I'd get more concave in the rear and front??
I took a few more with my phone in case I don't get a chance to take some further away with an actual camera this weekend. If I do, expect them Sunday afternoon/evening.i was hoping to see these on a 350. Did you go with R spec spacing? Can you cake some more photo from a little farther away.