PBD tuning issues...

[s550_from_NJ]

Loaded up tune sent from them. Went on fine. On initial start up...low oil pressure indicator. Ok.. no biggie..seen this with some Lund tunes before.

So...return to stock and wait for revision...but....when i return to stock i get the PO315...relearn crank code..???

Anyone have this issue before?

Sent data logs over and waiting to hear back. No codes were present prior to tuning and car was running fine.....still is....even with CEL on...

Sponsored

 

[LOL WUT]

What tuning device do you have? NGauge and I believe SCT4 can complete the crank relearn, should resolve the code.

 

[kevinvan6000]

I also suggest running the crack relearn procedure.

 

[s550_from_NJ]

What tuning device do you have? NGauge and I believe SCT4 can complete the crank relearn, should resolve the code.

I tried to clear the code but apparently it didn’ t. Where would you find the relearn feature on the SCT?

 

[s550_from_NJ]

What tuning device do you have? NGauge and I believe SCT4 can complete the crank relearn, should resolve the code.

Just found it

 

[LOL WUT]

Just found it

Excellent! Hope that works for you.

 

[s550_from_NJ]

Excellent! Hope that works for you.

Yea it did. Startled my entire development by reving but fixed it. Thank you

 

[s550_from_NJ]

Update.....

PBD final revision and all went well.....except..... my cooling fan turns on almost immediately and stays on. All temps are normal and it never did this before. Hoping it’s on their end involving the t stat like Lund.

Sponsored